Here, I’d like to feedback something I’ve tried with Allscanner VXDIAG VCX NANO Ford diagnostic tool and FORScan software.
I can add FORScan regarding the VXDIAG VCX Nano for Ford/Mazda. I took mine apart and no bluetooth module is present. The bluetooth capabilities advertised on the main Allscanner site it not accurate. I can not speak for the WIFI version but I have the USB version and have used it with my 2003 Mazda 6 V6 and AFTER installing the “pass-thru” driver (J2534) it works perfectly and fast with FORSCAN.
The VCX Nano I took apart seems to be a custom design to emulate in hardware part of the hardware/software of the VCM II but the driver is most important too. I did not take pictures but gently peeling down the stickers reveals 4 screws. Once inside it is a very simple board with a ST micro cortex M4 STM32F4 Series based micro controller doing the work. The FT serial to usb chip-set and some caps and a space that was blank for I assume either the WIFI or Bluetooth module. I googled the device and did see a Russian site where a guy took apart a VW version and it had more chips and and older generation micro-controller.
Soldering looks like reasonable quality surface mount and no hand work or redo’s.
Soldering looks like reasonable quality surface mount and no hand work or redo’s.
First of all install VCXManager and this driver:
And second configure ForScan how this image:
Its run perfectly
Note that please update your VCXmanager and drivers to the latest version.
http://blog.obdii365.com/2018/08/13/vxdiag-vcx-nano-ford-works-with-forscan-software/
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.